Search This Message Board:
Massey TO35 Throttle spring
[ Save This Page ] [ Follow Ups ] [ Post Followup ] [ Massey Ferguson Tractor Discussion Forum ] [ FAQ ]
Post a Followup
||I am a bit confused. I disassembled my Massey in September to rebuild it. I almost ready to start it. I have everything together except the large stout throttle spring hanging from the clamp on the throttle shaft supported at the thermostat housing. The govener is attached to the same shaft. What the heck does the spring attach to? Did I misplace a bracket or mounting part?
||It would be cool if a picture of this area could be sent to me. email@example.com dial up. firstname.lastname@example.org DSL
||the spring attaches to the thermastat housing.there is a small hole above where the gov. rod goes through