SSB Farm Tractor Parts, Manuals & Antique TractorsAftermarket Farm & Old Antique Tractor PartsTractor Service, Repair & Owners Operators Manual ShopTractor ImplementsTractor SeatsTractor Front End LoadersPedal Toy Tractors Farm Tractors For Sale ClassifiedsAntique Tractors For Sale ClassifiedsTractors Forum - Help & AdviceTractor, Gardening, Mowers & Outdoor Equipment BooksTractor ProductsContact Us
SEARCH MANUALS
FIND PARTS
How much is your farm tractor worth? Find resale prices for tractors built from 1939 through today, with complete specifications and serial numbers. Save 15% on our Official Tractor Blue Book sale!

Search This Message Board:

1020 John Deere help

Wally Need help aligning the center shaft of the two that goes through the transmission oil pump. It does not seem to go into the splined area that has the end with the nub on it. Id there any seceret to getting this aligned. Had to replace the oil pump and repair shaft that turns oil pump. Snow will be flying soon and this is the only form of snow removal I have.
DANIEL KENNEDY WALLY; IS IT THE OUTER SHAFT WITH THE TWO OUTER SPLINES? IF SO THE SHAFT THAT YOU DID YOU HAVE REPAIRED, DID YOU MAKE SURE THAT THE SHAFT WOULD SLIDE INTO THE PUMP BRG. AND PUMP GEAR BEFORE MOUNTING PUMP.MIGHT TRY THIS FIRST,SMALLER PRESSURE LINE ON RIGHT HAND SIDE,BLOW AIR PRESSURE IN LINE WHILE HOLDING SLIGHT PRESSURE ON END OF SHAFT.IF NO LUCK THEN PULL SHAFT OUT AND ALIGN SLOTS AS CLOSE AS POSSIBLE,THEN REMOVE LOWER PLUG ON SIDE OF CLUTCH HOUSING.HOLD PRESSURE ON SHAFT AND WITH BIG SCREWDRIVER TURN FLYWHEEL UNTIL SHAFT MOVES IN A LITTLE,MIGHT HAVE TO BUMP IN SLIGHTLY.POSSIBLE LOOSEN OUTER 4 PUMP BOLTS.HOPE THIS HELPS.MY#252-568-3969


Post a Followup



Enter Code Shown Above As it Appears:
Name:  
E-Mail:  
Subject:

Upload Picture (Optional - Choose File):


Comments:

Name:
Email:  

Sign Up For Our Monthly Special Sales!