||Am attempting to fit a Loader that was fitted to a B7100 to my B7001. It had been removed from the B7100 when purchased and not used! There is no identification but blue frames & orange boom says Kubota to me. I used the method endorsed by BILL in this Forum of cutting into the high pressure line from the pump.On first startup with boom cylinders attached but no boom my 3pt worked as normally -powerup-gravitydown.I raised the boom cylinders partway & on pushing the lever to lower there was an almighty crack & oil poured out the valve end cover & the pump connection.-- Some idiot,while previously welding a valve connector to the boom return pipe had welded the pipe shut !!!
WARNING!! WARNING!! - IF you don't see it working, check everything before startup!!
QUESTION - Can the larger oil return pipe from the loader discharge through the smaller rear 3pt pipe or does it have to flow into the filler hole on the top of the trans. as on the original B7100??.