Search This Message Board:
wont start ym2210 head gasket replaced
| brent |
run good.had small leak on right side. put in new head gasket now wont start. bleed all the fuel lines.the only thing i did was cranked over a little with head off to clean the carbon off the top of the pistons. left everthing just as it was .would this efect anything.used all the bleeders.could i had changed the timing, white make comes out when i crank it over. thanks you, guys are great!!!!
|
| norm |
How, (in detail), did you bleed the lines? There is nothing to get out of time just by removing the head.
|
| brent |
thanks, first i filled the tank with fresh fuel. then cleaned the filter boul. then the 2 screws on the filter boul and filled the boul till fuel come out of the 2 screws. then went to the top of the fitting going into the fuel pump until fuel come out of that. 10 seconds. then went up to the injectors and cracked them and cranked till fuel come ouy them. it just come out in small bursts. nothing just wont start. put everything back ex. the way it come out. thanks
|
| norm |
I would go back and try it again. Open and close the bleed screws one at a time, first the one before the filter until only fuel, no air, then the other, then the one at the pump. Did you check valve adjustment after re-assembly?
|
| brent |
thanks norm, no i just set the head back on the way it come off. should i pull the valve cover and reset the valves to specs.could they be out of adjustment. thanks again
|
Post a Followup
