Follow up question on my YM3110

How much is your farm tractor worth? Find resale prices for tractors built from 1939 and 2008, with complete specifications and serial numbers. Save 10% on our Official Tractor Blue Book sale!

Search This Message Board:

Follow up question on my YM3110

Scott

Here's the original question: I've got a Yanmar YM3110. While bush hogging the other day the tractor quit moving and the hydraulics holding the cutting deck lowered the deck. I checked the fluids and all seemed to be okay. After about 30 minutes I cranked the tractor back up, I was able to raise and lower the bush hog and the tractor moved again. After about 15 minutes of bush hogging everything stopped working again. The motor was still running but it would not move nor could I raise and lower the bush hog. Any ideas??????

Al advised me to change the spin-on filter and to clean the screen. Al also said that this could be done by searching underneath for three bolts in a triangular pattern around a couple inches apart. With the fluid drained, undo the bolts and pull out the screen, noting how it went in. Clean and replace.

I looked for thesethree bolts in a triangular pattern and could not locate them. However, there are five bolts in "dice" pattern with the center bolt being a little larger than the other 4???? Would this be what I am looking for?

lens

3 bolt, right side in front of axle.

[ Save This Page ] [ Follow Ups ] [ Post Followup ] [ Yanmar Tractors Discussion Forum ]
Post a Followup

Enter Code Shown Above As it Appears:
Name:
E-Mail:
Subject:

Upload Picture (Optional - Choose File):

Comments:

Name:

Email:

Sign Up For Our Monthly Special Sales!