2n hydraulic problem

How much is your farm tractor worth? Find resale prices for tractors built from 1939 and 2008, with complete specifications and serial numbers. Save 10% on our Official Tractor Blue Book sale!

Search This Message Board:

2n hydraulic problem

phil white	Hi i hope someone can help! just purchased a 1946 2n with a sherman trans.It has a backblade.I drove and operated the blade for 10 min. The blade locked in the up position about a foot off the ground.It won't go up or down. I removed the oil (which was milky) and replaced it with hyd tran oil.At this time the arms would come up a little each time i engaged the clutch but wouldn't go down.(all levers engaged and the pto is turning) this time when i removed the oil i allso removed the presure test plug and the arms went down, i then flushrd it with diesel fuel and replaced the oil again. Still nothing. there is no spray or turbalance when inspected thru dip stick cover.Sure could use some advice on what to do next.
Ken N Tx	What type of oil are you using??
Bob G	Sounds like the exhaust control valve may be stuck. if you do not have one i owuld get the I&T FO-4 service manual. has a good section on the hydrualic system
Ralph Westwood	I am having a similar problem - did you find out what was causing the problem and how to fix it? Thanks for any advice. Ralph

[ Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]
Post a Followup

Enter Code Shown Above As it Appears:
Name:
E-Mail:
Subject:

Upload Picture (Optional - Choose File):

Comments:

Name:

Email:

Sign Up For Our Monthly Special Sales!