SSB Farm Tractor Parts, Manuals & Antique TractorsAftermarket Farm & Old Antique Tractor PartsTractor Service, Repair & Owners Operators Manual ShopTractor ImplementsTractor SeatsTractor Front End LoadersPedal Toy Tractors Farm Tractors For Sale ClassifiedsAntique Tractors For Sale ClassifiedsTractors Forum - Help & AdviceTractor, Gardening, Mowers & Outdoor Equipment BooksTractor ProductsContact Us
SEARCH MANUALS
FIND PARTS
How much is your farm tractor worth? Find resale prices for tractors built from 1939 through today, with complete specifications and serial numbers. Save 15% on our Official Tractor Blue Book sale!

Search This Message Board:

1086 steering

J.P I replaced my MCV pump due to the old one blowing out its seal , it all worked good until my steering gave a hard jerk and then I slowly lost my power steer, the brakes and TA and the clutch work normal but not my steering , it doesn't work right from startup but all other functions do , is my pump going or is the relief stuck open any ideas thanks in advance
4240 turbo Maybe a bad steering cylinder. Start engine and left it run, turn the wheel a few minutes. If one of the cylinders is is getting warm it's bad, passing fluid internally.
4240 turbo Looked at a 1066 today(one steering cylinder) I had it confused with my Case (two steering cylinders). But it still works the same way, if the cylinder is getting warm its passing fluid. If that's not it you need a flow meter-psi gauge-cut off valve combo to plumb in inlet to steering motor(steering wheel control valve). Then you can diagnose steering motor or supply problem. Wish it was easier and steel lines are difficult to deal with. Maybe you will get a been there done that,good luck.


Post a Followup



Enter Code Shown Above As it Appears:
Name:  
E-Mail:  
Subject:

Upload Picture (Optional - Choose File):


Comments:

Name:
Email:  

Sign Up For Our Monthly Special Sales!