Search This Message Board:
Farmall C wont take load
| harvey |
My C Wouldn't start, found carb (carter)gasket ruined, made new one and cleaned carb. Replaced all ignition parts. Now tractor starts and idles nice but misses badly when under load - even just moving itself in 2nd. if blip throttle open from idle tractor chokes and sometimes dies. Good compression, 20" vacumn, spark at all plugs. put old condenser and coil back, no difference. if pull the manifold plug above carb hold finger over hole and allow little air in RPM rises smoothly as allow more air then as too much air, chokes and dies. removed oil bath, no difference. I think problem has to be in carb - Thanks for any thoughts.
|
| digger460 |
With tractor idling remove one spark plug wire at a time and see if it makes a difference. Could be bad wire or plug. My 460 was doing the same thing and I found out I had a bad plug. Had just replaced the plugs a couple months before.
|
| harvey |
Digger, thanks for the idea. Tried it but no change.
|
Post a Followup