Search This Message Board:
Zetor 5211 will not move. Clutch seems to be stuck engaged
| Chris Butts |
I haven't owned the Zetor 5211 for very long, so I do not know much about them. I was bush-hogging and the Tracktor was very slow after lifting my foot off the clutch. After a short period, it would come up to speed. Then I stopped and the Tractor wouldn't move again. I can shift into gear or forward and reverse without pressing the clutch. Bled the clutch and it had fluid...no fluid leaking from the slave cylinder. Any ideas on what the problem may be?
|
| hay |
sounds like the clutch went south on ya. might as well split it and install a new clutch or have someone do it for ya. a big job on any size tractor. BTDT several times.
|
| hay |
one thing you might try is look for an inspection plate somewhere on the bellhousing. if there is a hole try to stick a pry bay or very large flat blade screwdriver in there and try to pry the clutch plate. sometimes they stick, but yours sounds more like its just gone. try befroe splitting. good luck.
|
| Adam Wine |
check your master cylinder at clutch pedal. It may be froze or has a leak. Slave cylinder needs to have 1/2 minimum travel.
|
| paul venables |
what would cause 5211 to boil and blow oil out of breather pipe
|
Post a Followup
