| Barry Long |
The timing on my 273 baler has broke a chain. After fixin the chain the timing is not correct.
How do you reset the timing on a new holland baler?
|
| clinton |
did you ever figure it out? lol
could you please tell me?
|
| cat |
I can help you threw timing if still needed e-mail me to get my atention if you still need help
|
| Jfavor |
Mine broke the chain and a needle also. I ordered a manual. It says: The front crank should be pointing straight up. There two marks on the frame that it should be between. There's also two marks by the rear sprocket. These should be aligned across from each other. Make sure all backlash is out. Needle yoke must be up and in home position. Properly timed the needles will be entering the bale chamber just as the plunger starts to pass them (moving rearward).
|
| Tim Giger |
does anyone know were I can Get a drive shaft for this bailer. I need from the tractor to the baler.
|
Save This Page ] [ Follow Ups ] [ Post Followup ] [ Antique Tractor Discussion Forum ] [ FAQ ]