Re: relay?from starter to fuel shut off solenoid

[

Save This Page ] [ Follow Ups ] [ Post Followup ] [ Kubota Tractors Discussion Forum ]

Allis Chalmers Avery Bobcat Case David Brown Caterpillar Cockshutt Deutz Euclid Ford International Farmall

John Deere Kubota Massey Ferguson Minneapolis Moline Mitsubishi Satoh New Holland Oliver White Zetor Miscellaneous (OTHER)

| SSB Farm Tractor Parts, Manuals & Antique Tractors

| Aftermarket Farm Tractor Parts

| Service & Repair Farm Tractor Manuals |

| Rear View Backup Camera |

| Pedal Toy Tractors

| Tractor Books

| Tractor Data / Info / Specs

| Tractor Blog

| Antique Tractors History

| Related Sites

| Rustic Home |

SEARCH MANUALS

MAKE:	MODEL:

FIND PARTS

MAKE:	PART:

Search This Message Board:

Posted by Butch on Tuesday, November 03, 2009:

In Reply to: relay?from starter to fuel shut off solenoid posted by rustebad on Tuesday, November 03, 2009:

The older models have current to the valve while
running. You should have current on the valve
wire after it starts. If not, check the switch
to see why it doesn't have current. You could
move the wire to the run side of the switch on
a good terminal that goes off when the switch is turned off.
The newer models do not have current on the
valve all the time. I think it gets a shot of
current when it's turned on to pop the valve
into the correct position, then a shot of current to pop the valve back off when turned
off.

[

Save This Page ] [ Follow Ups ] [ Post Followup ] [ Kubota Tractors Discussion Forum ]

Follow Ups:

Post a Followup