| | SSB Farm Tractor Parts, Manuals & Antique Tractors | | Aftermarket Tractor Parts | | Tractor Service & Repair Shop Manuals | |
| | Tractor Implements | | Tractor Seats | | Trailer Parts | | Tractor Loaders | | PTO Generators | | Rear View Backup Camera | |
| | Pedal Toy Tractors | | Tractor Books | | Antique Farm Tractors Blog | | Antique Tractors History | | Rustic Home | |
Search This Message Board:
Posted by Ben Hucks on Wednesday, September 30, 2009:
I have a 87 model 2WD 4050. I am trying to move the hubs out to get a wider stance. The bugs are just about 2" from being all the way in and i would like to move them out about 5" on each side. The guys i bought it from ran duals on it some. The hubs are seized up by rust it seems. I loosened the 3 bolts on the inside and outside of the hubs, ran the push bolts as far in as i could and it didn't loosen them up at all. I used a few more rather shade tree techiques that required heat a huge hammer and a long piece of round bar and still nothing. Any suggestions on getting them loosened up so i can run them out i am open to.
- Re: 4050 Hubs Ronald Butler Thursday, October 01, 2009
(0)
Post a Followup
