[ 
Save This Page ] [ Follow Ups ] [ Post Followup ] [ International Farmall Tractors Discussion Forum ]
Save This Page ] [ Follow Ups ] [ Post Followup ] [ International Farmall Tractors Discussion Forum ]
| | SSB Farm Tractor Parts, Manuals & Antique Tractors | | Aftermarket Tractor Parts | | Tractor Service & Repair Shop Manuals | |
| | Tractor Implements | | Tractor Seats | | Trailer Parts | | Tractor Loaders | | PTO Generators | | Rear View Backup Camera | |
| | Pedal Toy Tractors | | Tractor Books | | Antique Farm Tractors Blog | | Antique Tractors History | | Rustic Home | |
Search This Message Board:
Posted by charlie on Friday, November 06, 2009:In Reply to: using sleeves and pistons out of farmall 130 in farmall c block posted by Charlie on Thursday, October 15, 2009:
I found my answer in an older forum answer: Hugh wrote this about a super a (113)engine, and super c(123) engine. I guess old hugh will always be around!Quote,
"Hugh MacKay: Clydeman: All Super C and Super A after serial number 310300 use block part number 354898 R1. Number is behind oil filter. The difference is all Super A after 310300 use a thicker sleeve giving 3" bore and 113 cu in. Super C uses 3-1/8" bore giving 123 cu in. They can be changed both ways, just a matter of changing sleeves and pistons".
Should be the same for my old c (113 cid) and 130(123 cid). Thank you Mr. Hugh, where ever you are
[ Save This Page ] [ Follow Ups ] [ Post Followup ] [ International Farmall Tractors Discussion Forum ]
Save This Page ] [ Follow Ups ] [ Post Followup ] [ International Farmall Tractors Discussion Forum ]Post a Followup
