Save This Page ] [ Follow Ups ] [ Post Followup ] [ International Farmall Tractor Discussion Forum ] [ FAQ ] Save This Page ] [ Follow Ups ] [ Post Followup ] [ International Farmall Tractor Discussion Forum ] [ FAQ ]
| | SSB Farm Tractor Parts, Manuals & Antique Tractors | | Tractor Parts | | Tractor Manuals | | Tractor Implements | | Tractor Seats | |
| | Rear View Backup Camera | | Pedal Toy Tractors | | Tractor Loaders | | PTO Generators | | Fuel Saver Efficiency Additive | |
| | Rustic Home Decorating & Decor | | Tractor Books | | Trailer Parts | | Antique Farm Tractors Blog | | Antique Tractors History | |
HI
I purchased a international 656D (gear transmission) with a aftermarket frontend loader on it and it is hooked to the rear tractor hydraulic couplers. I am installing a double spool valve on it that came with the tractor (but never installed) and can't seem figure out were to plumb in the pressure side of the valve and the return side? I was planning to supply the loader from the clutch side of the tractor and t into the hydraulic lines(there are two large line one goes to the three point under the seat and the other goes up by the steering wheel) but i'm not sure were to install the return line form the loader. Can anyone help. please email me at dctrinkle@aol.com