Save This Page ] [ Follow Ups ] [ Post Followup ] [ Caterpillar Tractor Discussion Forum ] [ FAQ ] Save This Page ] [ Follow Ups ] [ Post Followup ] [ Caterpillar Tractor Discussion Forum ] [ FAQ ]
| | SSB Farm Tractor Parts, Manuals & Antique Tractors | | Tractor Parts | | Tractor Manuals | | Tractor Implements | | Tractor Seats | |
| | Rear View Backup Camera | | Pedal Toy Tractors | | Tractor Loaders | | PTO Generators | | Fuel Saver Efficiency Additive | |
| | Rustic Home Decorating & Decor | | Tractor Books | | Trailer Parts | | Antique Farm Tractors Blog | | Antique Tractors History | |
In Reply to: 955 Brand New Used posted by Mark B. on Friday, April 18, 2008:
Hi Hector,
Put new points in last nite but could not find gap in any of my manauals. Did pre measure old ones and they were @ .035 Put new points in and could not not with adj.cam screw even get close
so set as wide as possible @ .028 guessing.Anyway no spark at all except GRD'D mag
wire. Got steel yesterday to build perch off RT.
lower lift cyl. and am building. Very concerned with Main throttle only allowing 5 or 6 clicks pull out. W.G. says may be oil pressure related, I HOPE! Will look for side plate access and remove cover an LOOK SEE! Any way I'm Hell Bent to fire where throttle is @! Trunion will not poke thru the dash. Figure I'll get lit on ETHER if It won't fire on it's own. How much ether can this 4 1/2 Bore Baby take. I will use very little trust me. And W.G. am taking a firexstingisher as a back up to shut down thru bottom of air cleaner.Will also take a plate.
THANX GUYS! Wish me Luck and all PRAYERS ACCEPTED! The Dude.