Save This Page ] [ Follow Ups ] [ Post Followup ] [ Caterpillar Tractor Discussion Forum ] [ FAQ ] Save This Page ] [ Follow Ups ] [ Post Followup ] [ Caterpillar Tractor Discussion Forum ] [ FAQ ]
| | SSB Farm Tractor Parts, Manuals & Antique Tractors | | Tractor Parts | | Tractor Manuals | | Tractor Implements | | Tractor Seats | |
| | Rear View Backup Camera | | Pedal Toy Tractors | | Tractor Loaders | | PTO Generators | | Fuel Saver Efficiency Additive | |
| | Rustic Home Decorating & Decor | | Tractor Books | | Trailer Parts | | Antique Farm Tractors Blog | | Antique Tractors History | |
Got a Cat. 933 loader mid 60's. hand clutch...wet. pulls but is weak. pull top plate, there are two pins with plates and nuts holding against the large threaded drum. I loosen the nuts, turn threaded drum in and it goes about an thread or two. Too far...cant engage clutch. If I set it only to where I can engage the clutch, it works, and then the drum pops back out. Its like its missing the thread or not being threaded in far enough. Is this the adjustment or is there another way? Im at a loss.