580K Phase3

So it is a late model 580K
Went out this morning warmed it up a few minutes.
(it is cold about 32F windy) anyway i engage the shuttle forward and it takes a few seconds for it to get going (it has been doing this for the last few months) but it is laboring like it is in second or third so i shift to one and lose drive.
Nothing.
So i check it over.
Drive shaft is turning.
Gear shift is working (i can feel it engaging the gears)
Clutch cut out solenoid has ground and receives power when you hit either button.
Front drive shaft engages and disengages.
Tires rotate slowly forward regardless of shuttle position unless you give it throttle then they stop.
I checked the fluid level (but cannot figure out if you check it running or shut down) shut down it is way full, running it barley touches stick.
Any ideas? I do not have anyway to test pressures.

[

Save This Page ] [ Follow Ups ] [ Post Followup ] [ Case Tractors Discussion Forum ]

Follow Ups:

Re: 580K Phase3 James Sunday, November 23, 2008 (0)
Re: 580K Phase3 alrman Sunday, November 23, 2008 (0)
Re: 580K Phase3 James Saturday, November 22, 2008 (0)

Post a Followup