Save This Page ] [ Follow Ups ] [ Post Followup ] [ Case Tractor Discussion Forum ] [ FAQ ] Save This Page ] [ Follow Ups ] [ Post Followup ] [ Case Tractor Discussion Forum ] [ FAQ ]
| | SSB Farm Tractor Parts, Manuals Antique Tractors | | Tractor Parts | | Tractor Manuals | | Tractor Implements | | Tractor Seats | |
| | Rear View Backup Camera | | Pedal Toy Tractors | | Tractor Loader | | PTO Generator | | Fuel Saver Efficiency | | Antique Tractors | |
In Reply to: Case 1700 ignition problem. posted by Lee on Saturday, September 22, 2007:
The condenser body should be grounded to a good ground,the base plate of the distributor that the points anvil sit on also must have a good ground, sometimes there is a ground wire between the distributor base and the distributor body plate breaks due to the movement of the base plate as it moves to adavance the ignition,the points contact striker the part that opens and closes should be insulated and have clearance when open of a certain spec,usuall 0.015", with the points clean and open switch the ignition on,with a simple test lanp check to see if there is power at the points striker,there should be if so see if the test lamp lights when grounded to the base plate of the distributor,if not check why, it has to have ground, some weeks past I posted for someone else on checking the ignition system,go to the post Case sc wiring Fri 31st Aug where I explain how to check the ignition system without any special tools.
AJ