case ih 275mfd kingpin/pinion shaft orientation on front drive

[

Save This Page ] [ Follow Ups ] [ Post Followup ] [ Case Tractors Discussion Forum ]

Allis Chalmers Avery Bobcat Case David Brown Caterpillar Cockshutt Deutz Euclid Ford International Farmall

John Deere Kubota Massey Ferguson Minneapolis Moline Mitsubishi Satoh New Holland Oliver White Zetor Miscellaneous (OTHER)

| SSB Farm Tractor Parts, Manuals & Antique Tractors

| Aftermarket Farm Tractor Parts

| Service & Repair Farm Tractor Manuals |

| Rear View Backup Camera |

| Pedal Toy Tractors

| Tractor Books

| Tractor Data / Info / Specs

| Tractor Blog

| Antique Tractors History

| Related Sites

| Rustic Home |

SEARCH MANUALS

MAKE:	MODEL:

FIND PARTS

MAKE:	PART:

Search This Message Board:

Posted by Mike on Sunday, November 01, 2009:

I am in the process of installing new hubs on a Ace IH 275 mfd 4 wheel drive tractor. It was built by Mitsubishi uses the same or very similar front drives as the MT 300D.
My question concerns the pinion shaft that drives the front wheels, part # 69541-61501. The splines on one end have a stop that prevents the gear from moving beyond a point on the shaft. The other end does not have this, the gear can move all the way to the bevel where the splines taper to the shaft toward the middle.
Should the end with the stop on the splines go to the top or to the bottom of the spindle.
I can send pictures if it helps and any help would be greatly appreciated.
Thank you in advance,
Mike

[

Save This Page ] [ Follow Ups ] [ Post Followup ] [ Case Tractors Discussion Forum ]

Follow Ups:

Drawing AJ Monday, November 02, 2009 (0)
Re: case ih 275mfd kingpin/pinion shaft orientation on front drive AJ Monday, November 02, 2009 (0)

Post a Followup