MM 1953 Model BF

[ Save This Page ] [ Follow Ups ] [ Post Followup ] [ Minneapolis Moline Tractor Discussion Forum ] [ FAQ ]

Allis ChalmersAveryBobcatCase David BrownCaterpillarCockshuttDeutzEuclidFordInternational Farmall
John DeereKubotaMassey FergusonMinneapolis MolineMitsubishi SatohNew HollandOliverWhiteZetorMiscellaneous (OTHER)

SSB Farm Tractor Parts, Manuals & Antique TractorsAftermarket Farm & Old Antique Tractor PartsTractor Service, Repair & Owners Operators Manual ShopTractor ImplementsTractor SeatsTractor Front End LoadersPedal Toy Tractors Farm Tractors For Sale ClassifiedsAntique Tractors For Sale ClassifiedsTractors Forum - Help & AdviceTractor, Gardening, Mowers & Outdoor Equipment BooksTractor ProductsContact Us
| SSB Farm Tractor Parts, Manuals & Antique Tractors | Aftermarket Farm Tractor Parts | Service & Repair Farm Tractor Manuals |
| Tractor Implements | Tractor Seats | Trailer Parts | Tractor Loaders | PTO Generators | Small Engines | Rear View Backup Camera |
| Pedal Toy Tractors | Tractor Books | Tractor Data / Info / Specs | Tractor Blog | Antique Tractors History | Related Sites | Rustic Home |
SEARCH MANUALS
MAKE: MODEL:
FIND PARTS
MAKE: PART:

Search This Message Board:
Posted by Del Harris on Tuesday, September 21, 2004:

I have a MM 1953 BF I need a few parts. The BF presently needs a clutch assembly rework.

1) clutch disk (ten teeth spline 9" dia.)
2) clutch release bearing
3) pressure plate or just replacement release
fingers
4) pilot bearing in flywheel
5) clutch shaft rear bearing
6) 2 drive shaft universal joints

I figure on the bearings I probably can take them
to a bearing distributer and cross reference them.
However, I'm not sure if this will work for all
of the bearings I need.
The biggest obvious dilemas are the preasure
plate, clutch disc and u joints. The preassure
plate surface could be cleaned up, but the release
fingers on the plate are shot. The clutch disc probably could be relined, but I don't know any sources for this operation.
I would like to do further work on this tractor,
and am interested in any good contacts and parts
sources.
I presently own a manual by Intertec which
contains a collection of MM Shop manuals BF
included. This manual has been very helpful in
many ways, but week in some others.
I would also like to do some work on the
Hydraulics on the BF, MM calls it a HKG System,
but my BF manual doesn't show a breakdown of it.
While looking at other MM systems in my shop
manual collection for other MM tractors, I
discovered my HKG hydraulic system looks identical
to the MM Uni-matic Hydraulic system. The only
differences I can see are cosmetic, like tank
mounting and control manifold plumbing. Pump, ram
and contol resevoir look the same.
I was wondering if there are any other manuals
which may break down the Hydrulics, specific to
the BF model beter than the one I have.

Thanks
Del Harris

Follow Ups:


Post a Followup

Name:
E-Mail:

Subject:

Comments:

Email Notification: If you check this box, email will be sent to you whenever someone replies to your message. You must include your email address above to receive this notification.

[ Save This Page ] [ Follow Ups ] [ Post Followup ] [ Minneapolis Moline Tractor Discussion Forum ] [ FAQ ]