Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]
| | SSB Farm Tractor Parts, Manuals & Antique Tractors | | Aftermarket Tractor Parts | | Tractor Service & Repair Shop Manuals | |
| | Tractor Implements | | Tractor Seats | | Trailer Parts | | Tractor Loaders | | PTO Generators | | Rear View Backup Camera | |
| | Pedal Toy Tractors | | Tractor Books | | Antique Farm Tractors Blog | | Antique Tractors History | | Rustic Home | |
In Reply to: Marvel-Schebler carb rebuild posted by Bill Spencer on Saturday, October 03, 2009:
Out of the four unidentified parts, I've found a home for the spring (choke flapper) and the black seal (throttle shaft). The last two remain a mystery! The main adj.needle does have a gasket between the spring and the body.
I've assembled all the rest, installed carb on tractor, started tractor and set speeds and mixtures......all seems O.K. at this point.
Since I don't have the gas tank/hood installed I have not run the tractor under load yet. I may have to make further adjustments etc. then.
In closing, thanks to all who have responded the my questions. Your experience, knowledge and insight is greatly appreciated. Altho knowledged in automotive and power generation equipment, rebuilding this tractor from literally basket/boxes was a new experience for me. Thanks again!
Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]Post a Followup
