[ 
Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]
Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]
| | SSB Farm Tractor Parts, Manuals & Antique Tractors | | Aftermarket Tractor Parts | | Tractor Service & Repair Shop Manuals | |
| | Tractor Implements | | Tractor Seats | | Trailer Parts | | Tractor Loaders | | PTO Generators | | Rear View Backup Camera | |
| | Pedal Toy Tractors | | Tractor Books | | Antique Farm Tractors Blog | | Antique Tractors History | | Rustic Home | |
Search This Message Board:
Posted by Paul Roberts on Saturday, September 12, 2009:In Reply to: Lever on right side of 8n trans case posted by Norm Jones on Friday, September 11, 2009:
This small lever is the position control lever.
When it is straight up (vertical) the lift is in position control. The hydraulic lift quadrant lever will position the implement in relation to the quadrant lever position. When the small lever is down (horizontal) the lift is in draft control mode. Plowing is about the only time you use draft control. The lift will raise or lower the plow slightly to maintain a constant draft pressure which keeps the furrow at a uniform depth.
[ Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]
Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]Post a Followup
