Re: 8n Lift

[

Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]

Allis Chalmers Avery Bobcat Case David Brown Caterpillar Cockshutt Deutz Euclid Ford International Farmall

John Deere Kubota Massey Ferguson Minneapolis Moline Mitsubishi Satoh New Holland Oliver White Zetor Miscellaneous (OTHER)

| SSB Farm Tractor Parts, Manuals & Antique Tractors

| Aftermarket Farm Tractor Parts

| Service & Repair Farm Tractor Manuals |

| Rear View Backup Camera |

| Pedal Toy Tractors

| Tractor Books

| Tractor Data / Info / Specs

| Tractor Blog

| Antique Tractors History

| Related Sites

| Rustic Home |

SEARCH MANUALS

MAKE:	MODEL:

FIND PARTS

MAKE:	PART:

Search This Message Board:

Posted by Bob G on Sunday, July 12, 2009:

In Reply to: 8n Lift posted by Mark B on Sunday, July 12, 2009:

make sure you get the gasket kit and install ALL of the gaskets dry with not sealer. all the bolts in the cover has to come loose and the left arms. I oculd not remove the center link, bolts rusted in, so i left it hook up and kinda of rolled it over to replace the piston. Not a hard job at all. A bit hard to get the control rod in place but just be careful you don't bend anything. once you get the cover off, i think there are 4 bolts holding the cylinder in place.

Don't forget the three small gaskets!

[

Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]

Follow Ups:

Post a Followup