2n hydraulic problem

Hi i hope someone can help! just purchased a 1946 2n with a sherman trans.It has a backblade.I drove and operated the blade for 10 min. The blade locked in the up position about a foot off the ground.It won't go up or down. I removed the oil (which was milky) and replaced it with hyd tran oil.At this time the arms would come up a little each time i engaged the clutch but wouldn't go down.(all levers engaged and the pto is turning) this time when i removed the oil i allso removed the presure test plug and the arms went down, i then flushrd it with diesel fuel and replaced the oil again. Still nothing. there is no spray or turbalance when inspected thru dip stick cover.Sure could use some advice on what to do next.

[

Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]

Follow Ups:

Re: 2n hydraulic problem Ralph Westwood Monday, June 15, 2009 (0)
Re: 2n hydraulic problem Bob G Wednesday, May 20, 2009 (0)
Re: 2n hydraulic problem Ken N Tx Wednesday, May 20, 2009 (0)

Post a Followup