Re: rod bearing on a 9N engine

[

Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]

Allis Chalmers Avery Bobcat Case David Brown Caterpillar Cockshutt Deutz Euclid Ford International Farmall

John Deere Kubota Massey Ferguson Minneapolis Moline Mitsubishi Satoh New Holland Oliver White Zetor Miscellaneous (OTHER)

| SSB Farm Tractor Parts, Manuals & Antique Tractors

| Aftermarket Farm Tractor Parts

| Service & Repair Farm Tractor Manuals |

| Rear View Backup Camera |

| Pedal Toy Tractors

| Tractor Books

| Tractor Data / Info / Specs

| Tractor Blog

| Antique Tractors History

| Related Sites

| Rustic Home |

SEARCH MANUALS

MAKE:	MODEL:

FIND PARTS

MAKE:	PART:

Search This Message Board:

Posted by Bob G on Sunday, May 17, 2009:

In Reply to: rod bearing on a 9N engine posted by Don on Saturday, May 16, 2009:

Depends on why you looked in the first place. Was it knocking? Only one rod bearing bad? you could replace the bearing, clean up crank with some emory paper and then use some plastic gauge to see what the clearance is. should be 0.001 to 0.0035"

God luck

[

Save This Page ] [ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractors Discussion Forum ]

Follow Ups:

Post a Followup