Ford 9N carb adjustments

[ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractor Discussion Forum ] [ FAQ ]

Hop To Another Discussion Forum:
SSB Tractor (ssbtractor.com)Your Farm Tractor Supply Headquarters
Allis ChalmersAveryBobcatCase / David BrownCaterpillarCockshuttDeutzEuclid FordInternational Farmall
John DeereKubotaMassey FergusonMinneapolis MolineMitsubishi / SatohNew Holland OliverWhiteZetorMiscellaneous
HomePartsManualsProductsFeaturesContact Us
Antique Tractors ClassifiedsTractors ForumTractor BooksFarm Tractors Photo Classifieds
| SSB Tractor Home | Tractor Parts | Tractor Manuals | Tractor Seats | Tractor Implements | Rear View Backup Cameras |
| Pedal Toy Tractors | Backhoe Loaders | Front End Loaders | PTO Generators | Antique Tractors History | Related Links |

Search for:   Model (Ex. 8N, 9N, 600, 800):  
Search for Tractor Parts:Tractor Part (Use singular keywords... for example, "radiator" as opposed to "radiators"):

Search This Message Board:
Posted by John Opfer on Tuesday, March 25, 2008:

I am stumped... Have been trying to get this little girl to run nice and idle nicely. When I got it, I replaced the exhaust manifold gasket, installed new tune-up kit (points, plugs, condenser, rotor, cap) It would run okay on full throttle, but on idle it would not idle decent unless the choke was partly pulled out. There seemed to be some play in the throttle butterfly cross shaft, so I assumed there was air leaking in through the shaft. I then bought a new carb, installed it, and it runs the same as before. The adjustment on the idle needle get a little better when it bottomed out, but still needs the choke partly to run decently. The power adjusting needle seems to respond appropriately. Would it possibly be the interior of the manifold is corroded between intake and exhaust passages? Any suggestions?

Follow Ups:


Post a Followup



Enter Code Shown Above Exactly As it Appears:
Name:
E-Mail:

Subject:

Comments:

[ Follow Ups ] [ Post Followup ] [ Ford 9N, 2N, 8N, NAA Tractor Discussion Forum ] [ FAQ ]