|Allis Chalmers||Avery||Bobcat||Case David Brown||Caterpillar||Cockshutt||Deutz||Euclid||Ford||International Farmall|
|John Deere||Kubota||Massey Ferguson||Minneapolis Moline||Mitsubishi Satoh||New Holland||Oliver||White||Zetor||Miscellaneous (OTHER)|
|| SSB Farm Tractor Parts, Manuals & Antique Tractors||| Aftermarket Farm Tractor Parts||| Service & Repair Farm Tractor Manuals ||
|| Tractor Implements||| Tractor Seats||| Trailer Parts||| Tractor Loaders||| PTO Generators||| Rear View Backup Camera ||
|| Pedal Toy Tractors||| Tractor Books||| Tractor Data / Info / Specs||| Tractor Blog||| Antique Tractors History||| Related Sites||| Rustic Home ||
Hello, I am having trouble removing the gear from the pump drive shaft. I was able to remove the pump because the whole gear/shaft assemblly slid out the front, but I know during re-assemblly, in order to be sure the umbrella seals go in correctly, I think I need to insert the shaft into the pump first, then install the pump, but because the tractor gear does not fit through that hole on the back, I think it has to come off. There were two bolts going through holes in the gear, they appear to help index the gear to the shaft, then there is a large nut on the end of the shaft, but it will not budge. The only way to hold the shaft, is by the tang on the end. I'm worried I might snap the shaft at the skinny part. Is there a trick to removing this nut??
Post a Followup