Save This Page ] [ Follow Ups ] [ Post Followup ] [ Farm Tractor Discussion Forum ] [ FAQ ] Save This Page ] [ Follow Ups ] [ Post Followup ] [ Farm Tractor Discussion Forum ] [ FAQ ]
| | SSB Farm Tractor Parts, Manuals Antique Tractors | | Tractor Parts | | Tractor Manuals | | Tractor Implements | | Tractor Seats | |
| | Rear View Backup Camera | | Pedal Toy Tractors | | Tractor Loader | | PTO Generator | | Fuel Saver Efficiency | | Antique Tractors | |
I need some help getting a bearing/race out of a gearbox on my hay mower. I have a horizontal shaft with a ring gear on one end. The other end of the shaft goes through the gear box housing (where the bearing is) and the outside connects to a drive pulley. I have the pulley off, the outside seal and C-clip out. The bearing/race has to come out and not in. I have managed to drive the race about half way out but since I can't get a straight shot at it from inside the gearbox it has stopped. I can't get enough of a lick on it. There is no way to attach anything to the shaft to pull on it. The shaft is smooth. Picture a square box with a horizontal shaft entering one side. Where the shaft enters is where the bearing/race is.